12-07-2018, 02:30 PM
I see now, thanks! Maybe BuP4uk can figure it out on his eventually! For the Maximum Memory Frequency, see the setting right above that, I think maybe this is some fail safe or "Safe" memory speed thing, due to the one right above that. "MRC ULT Safe Config" but it's disabled by default so maybe changing the one you mentioned wouldn't apply at all, only a test would let you know. If it does nothing, enable that MRC ULT Safe Config and test again, then if nothing you know it's not what you want to downclock memory.
I think this is how you do what you want, you need to set several items to change the ram speed (Now, this may get limited by what you mentioned above, if enabled and set to some value = leave disabled, don't change and use this instead)
Memory profile >> Change to custom
Memory Reference Clock >> Choose 100 or 133, based on your desired outcome speed
QCLK Odd Ratio >> Enabled, so all multipliers can be used at either 100 or 133 above
Memory Ratio >> Set whatever your want (memory Reference Clock 100 or 133 x value set here >> 3-15 available)
Memory Voltage is also available to change, as well as many individual timings and command rate (NMode 0=Auto, 1=1T, 2=2T)
I think this is how you do what you want, you need to set several items to change the ram speed (Now, this may get limited by what you mentioned above, if enabled and set to some value = leave disabled, don't change and use this instead)
Memory profile >> Change to custom
Memory Reference Clock >> Choose 100 or 133, based on your desired outcome speed
QCLK Odd Ratio >> Enabled, so all multipliers can be used at either 100 or 133 above
Memory Ratio >> Set whatever your want (memory Reference Clock 100 or 133 x value set here >> 3-15 available)
Memory Voltage is also available to change, as well as many individual timings and command rate (NMode 0=Auto, 1=1T, 2=2T)