Bios Mods -The Best BIOS Update and Modification Source

Problem after flashing unlocked bios

That's weird, recover it by doing this.

I'll try to send you another bios file today, but I'm busy today.

Ok, thanks you.

I think it just messed up when flashing for some reason. Tried flashing the same file I sent you on my own computer and it worked both times. Try flashing it again after you recover it. So sorry that this happened.

Did you change any settings or install any different hardware after the mod?

Also I've had a lot of problems with the F.29 revision of those bios. I use an older release, F.13, on my laptop.

Here is the modified F.13 bios if you can't get the other one I posted to work.

Once again, I'm so sorry that there was a problem. To make it up to you, I could preform one of the following mods on your bios if you'd like

1. Custom splash screen logo
2. Replace one of the existing tabs with the hidden power tab
3. Remove wifi whitelist
4. Allow the use of the native AICPM kext for hackintosh

Thanks you. Settings is defaults. I'll try to flashing again after recovery.

Hi again. F.13. Settings is defaults.

---

(06-16-2013, 01:41 AM)donovan6000 Wrote: [ -> ]To make it up to you, I could preform one of the following mods on your bios if you'd like

1. Custom splash screen logo
2. Replace one of the existing tabs with the hidden power tab
3. Remove wifi whitelist
4. Allow the use of the native AICPM kext for hackintosh

I just need AHCI mode for my SSD, because it doesn't work. You can turn on only this in firmware?

Not sure why it's not working

Found a modded F.29 that camiloml uploaded. You can try it.

I'm out of ideas if that doesn't work.

Also just checked, and AHCI is enabled be default already. What happens when you try to use your SSD?

F.29 by camiloml is working normally, but after ~ 3+ reboots screen stops working. I dont know what does it depend.

Installing Windows doesnt start all the same. (BSOD after Windows logo: KERNEL.SECURITY.CHECK.FAILURE)
The point is not in the BIOS. I am doubtful what I ought to do.

My SSD is Kingston v300.

Based on page 3 of this document about you computer, it looks like it can only support a 160GB SSD. I don't think it's possible to fix this issue. I'd recommend returning it