03-13-2010, 07:16 PM
Pages: 1 2
03-14-2010, 01:39 AM
(03-13-2010, 07:16 PM)1234s282 Wrote: [ -> ]Have you tried resetting Optimized Defaults in BIOS?
How should I go about that?
03-14-2010, 05:12 AM
Go into BIOS , choose the "Load Optimized Defaults" setting , press F10 to save changes and reboot
Admin
Admin
04-09-2010, 12:16 AM
(03-13-2010, 12:31 PM)Parry Wrote: [ -> ]Found these issues with my new motherboard:
1) On re-boot am getting a PXE error message;
Quote:YUKON PXE v 6.22.1.33 (20070803)
©Copyright 2003-2006 Marvell ®. All Rights Reserved
Pre-Boot Execution Environvment (PXE)
©Copyright 1997-2003 Intel Corporation
PXE-E61: Media test failure, check cable.
PXE-M0F: Existing PXE ROM.
2) Vista too is loading up a bit slowly.
Checked my boot configuration it had;
External Device: Enabled
Network: Enabled
Disabled network as boot configuration, pressed F10 for Save & Exit. There was a black screen for about a minute or so.
Then I re-booted enabled the network boot configuration & notebook re-booted as earlier with the error message. Pls assist.
this is an older post, but i figure it answer it anyway...
change the boot order in the bios to hard drive first
its looking for a network boot. not finding a cable or server to read from and giving you the PXE error.
Nick
Pages: 1 2