Try this one :
Removed
Let me know
Regards
(10-18-2015, 05:13 AM)BDMaster Wrote: [ -> ]Try this one :
http://rghost.net/6jnBLVsNM
Let me know
Regards
Thanks for your time.
I have flashed the posted BIOS file via USB drive using M-Flash utility embedded in UEFI. It did flash ok without error messages. However after flashing I cannot get any display or beeps when I turn on the PC.
When I switch power on, I do get red LED on MoBo but do not get any display from eith VGA or DVI port. I cleared CMOS and tried to use a standalone VGA card bus still could not get display. I unhooked all drives and some times MoBo reboots but still no beeps and no display.
Any suggestions to get out of this situation.
Ok It seems Bricked !
I forgot to say to Flash from DOS using AFUDE238.exe like Support
suggest . . .
I will get a look about Bios Recoery for your MoBo !
Wait a bit please !
Regards
Recovery Dual Bios Procedure :
This MB have Multi BIOS feature and system will automaticaly bootup from 2nd Bios chip and help you recover your system from failure.
Try the below steps to recover your sytem from bios flash failure:
Step 1: Boot up your system and then press Del button to get in EFI BIOS Setup.
Step 2: Choose Setting> Security > Multi BIOS Auto Update and Change default option to “Enable”.
Press F10 to “Save Configruation and Reset”, then choose “Yes”.
Step-3: You will see the bios Flash process immediately after exit from bios setp,
Wait until bios update reaches 100%, then reset the system.
Note: Please do not turn off the system during the Bios Auto update procedure.
(10-19-2015, 04:35 AM)BDMaster Wrote: [ -> ]Recovery Dual Bios Procedure :
This MB have Multi BIOS feature and system will automaticaly bootup from 2nd Bios chip and help you recover your system from failure.
Try the below steps to recover your sytem from bios flash failure:
Hello,
-How do you know this motherboard has MultiBios feature? I have looked on the MSI website in detail and I could not find any reference about multi Bios.
- I do not have display from the Motherboard so I cannot see naything on screen. There is no way for me to see if I am in UEFI Bios Setup screen.
- Is there any way to force a falsh from a USb drive? I can make a bootable flash drive and edit an AUTOEXEC.BAT file. If I can find utility to force flash from a bootable drive without prompts, that would be great.
Regards.