Are you kidding me? What's all this about? Do you have or not a bios to run the E7600 on the 775I65G rev.3?
(07-23-2017, 03:32 AM)Ultor Wrote: [ -> ]Are you kidding me?
No requested information - no help.
Finally I found the bios mod for Wolfdale support:
https://ufile.io/jtp8g
The only problem: works with 775I65G rev 2.0!
Will it work with rev. 3.0?
You can try if you have hardware programmer to recovery.
And I repeat:
(07-23-2017, 01:42 AM)DeathBringer Wrote: [ -> ]Did you ran SYMCOMS in native DOS? What was the result?
What are DIMMs you using?
(07-23-2017, 02:17 AM)DeathBringer Wrote: [ -> ]Show a photo of results.
I have problems with SYMCOMS... the program don't works
I'm not sure that it wasn't your mistake. So I need a photo of results.
What're about current DIMMs?
Microcode in these files are the same.
If I use bios mod on rev.3 I lost the fan control.
(07-24-2017, 05:20 AM)Ultor Wrote: [ -> ]If I use bios mod on rev.3 I lost the fan control.
Does your E7600 work with this BIOS? Post TXT report of
CPU-Z.