02-06-2017, 10:45 AM
Hi everyone,
I've been reading different threads and learnt a lot. I'll start with a simple question and then give all the details because I've got a certain tendency to speak too much
I want to extract binaries from a Dell update file but when I process it with phoenixtool the output is a 10679K file while the motherboard has two chips:
if I use the usual procedure forcing the update with /s /f, the update utility only does the EC part skipping the three steps before:
- System BIOS
- Management Engine Firmware
- Intel® ME FW Upgrade
- EC BIOS
forgot to mention: tried to create the .exe file from bios.gz with DCCU but after showing the first page, when I browse to the file and click on create the server looks dead (file too big?)
thanks a lot!
Alessandro
I've been reading different threads and learnt a lot. I'll start with a simple question and then give all the details because I've got a certain tendency to speak too much
I want to extract binaries from a Dell update file but when I process it with phoenixtool the output is a 10679K file while the motherboard has two chips:
Code:
Intel (R) Flash Programming Tool. Version: 8.1.51.1476
Copyright (c) 2007 - 2013, Intel Corporation. All rights reserved.
Platform: Intel(R) Patsburg Chipset - Reserved DID 0x1D41
Reading HSFSTS register... Flash Descriptor: Valid
--- Flash Devices Found ---
MX25L6405D ID:0xC22017 Size: 8192KB (65536Kb)
MX25L1605A ID:0xC22015 Size: 2048KB (16384Kb)if I use the usual procedure forcing the update with /s /f, the update utility only does the EC part skipping the three steps before:
- System BIOS
- Management Engine Firmware
- Intel® ME FW Upgrade
- EC BIOS
forgot to mention: tried to create the .exe file from bios.gz with DCCU but after showing the first page, when I browse to the file and click on create the server looks dead (file too big?)
thanks a lot!
Alessandro