proceedure?
i ll put your file into a bootable stick with bios.bat
and i ll write a NEW bios?
dir
bios.bat
is that correct?
Make DOS USB-stick (e.g, by
Rufus)
Copy phlash16.exe and file with mod (JV50134m.WPH)
Boot into native DOS and run
phlash16 /x /s /c /mode=3 JV50134m.WPH
Once again you have right, it s too hot.
I will follow your advice and i buy a T 9600.
Hi, to dust off, could someone re-upload the bios that supported t7500 CPU for Aspire 5738z, please? Thanks!!
Show a photo of your T7500.
(02-07-2020, 10:42 AM)DeathBringer Wrote: [ -> ]Show a photo of your T7500.
I hope this is what you mean :-)
Hi, thank you it flashed without problems and my laptop boot normally, there is not microcode's lack POST message.
Hi, I have p8600 processor from my old thinkpad t400 and I decide to put it on my aspire 5738z. I update the firmware with the one in this thread but after I install the p8600 there was a black screen and the laptop don't even show the bios screen. I have tested all the firmwares in this forum but without success. When I return the original t4300 processor everything is ok and the laptop is working.
So my questions are :
1. Is the p8600 compatible with this laptop?
2. Could it be a ram incompatibility?
I have 3gb ram 1x2gb and 1x1gb
I have tried all possible combinations with the ram on different slots one by one and the result is always a black screen.
I will try to put all the data I have on photos.
vesman
Your laptop is base on GL40 withou support of FSB=1066 Mhz. So you can't use your P8600.
T8100, T8300, T9300 and T9500 are recommended.