Ok friend,
i am sorry
for this and It seems that BootBlock (Recovery need) is working but
something doesn't permit to load Bios !
I think You have to get the Tools (SPI PGM + Clip) to rewrite back the Firmware
and We will patch all You need this time and make any test !
They are cheapers ($.30,00 for all) and the procedure is easy !
Look here :
https://www.bios-mods.com/forum/Thread-R...5#pid74575
let me know
Regards
P.S. I will help You following staep by step in all procedure !!!
Ok I will wait your news, mate !
Regards
P.S. I leave none alone but follow any step of programming !
Ok. Today the Tools arrived.
Please send me the Driver and Software for the CH341A and give me help to Flash ist.
Thanks and Regards
Please mate,
let You listen me . . .
Before doing anything You have to read your Eeprom chips and make a
Full Dump Firmware (Backup) to save your laptop !!!
Upload it for me as i have to compare with your bios backup !
Here You go :
http://rghost.net/6rrRPtchr
let me know
Reagrds
Thanks for the Software.
When i put the conector on the IC - the flashe not connect the IC.
I tested on old Mainboards the connector and it works.
I think, i must unsolder the IC, to Read and Write the IC.
Regards
All aligned to Pin #1 from SPI PGM to Eeprom Chip ?
If all is correct then You're right and You have to remove It from MoBo to read and write !
Let me know
Regards