Bios Mods -The Best BIOS Update and Modification Source

Full Version: MSI ER710X
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Hello

I want to remove whitelist chechk

My bios

Manufacturer: MSI
Motherboard Model: er710
Bios revision: 1.45
Bios Type: AMI
Bios Download Link: http://download2.msi.com/files/downl...e/171b_145.zip
Current original card: PCI\VEN_168C&DEV_001C&SUBSYS_10261A3B&REV_01\4&25A D2F5B&0&0020

Thanks in advance!
Bios link broken, and... what error you receive when exchanging the card?
(03-09-2012, 02:29 PM)camiloml Wrote: [ -> ]Bios link broken, and... what error you receive when exchanging the card?

http://download3.msi.com/files/downloads...1b_145.zip This link is working

When i repleace wifi card, new card just not working, i can't turn it on. Control LED is alwyas off.

(03-10-2012, 05:41 AM)camiloml Wrote: [ -> ]http://www.bios-mods.com/forum/Thread-RE...est?page=3
This method has no effect. I can't turn on wifi card, and wifi card can't find any network.
(03-10-2012, 08:33 AM)mi42 Wrote: [ -> ]
(03-10-2012, 05:41 AM)camiloml Wrote: [ -> ]http://www.bios-mods.com/forum/Thread-RE...est?page=3
This method has no effect. I can't turn on wifi card, and wifi card can't find any network.

Then you're diong it wrong. Tapping pin 20 correctly means radio is always on not off.

Review the photo and tap the correct pin with a little bit of electrical isolation tape then insert carefully in the slot so that the pin 20 is isolated from its contact on slot.
(03-10-2012, 10:57 AM)camiloml Wrote: [ -> ]
(03-10-2012, 08:33 AM)mi42 Wrote: [ -> ]
(03-10-2012, 05:41 AM)camiloml Wrote: [ -> ]http://www.bios-mods.com/forum/Thread-RE...est?page=3
This method has no effect. I can't turn on wifi card, and wifi card can't find any network.

Then you're diong it wrong. Tapping pin 20 correctly means radio is always on not off.

Review the photo and tap the correct pin with a little bit of electrical isolation tape then insert carefully in the slot so that the pin 20 is isolated from its contact on slot.

Tahnks, I do it again with tape, and it now works fine. Big Grin