(11-13-2016, 09:02 AM)DeathBringer Wrote: [ -> ]Make & post a screenshot of regedit with expanded key HKEY_LOCAL_MACHINE\HARDWARE\DESCRIPTION\System\CentralProcessor\0
Post screenshots of first (CPU) & third (Mainboard) tabs of CPU-Z with native CPU.
What's the revision of your motherboard: 1.0 or 3.x?
Hey DeathBringer!
The board revision is 1.0. Atached you will find every print that you asked for.
If you can change the bios, is there any chance of revealing OC optins? Just in case.... lol
Tks a lot!
Try to flash
my mod.
After flashing go to BIOS and do
Load Defaults.
Reboot and make & post new screenshot of
regedit with expanded key
HKEY_LOCAL_MACHINE\HARDWARE\DESCRIPTION\System\CentralProcessor\0
(11-22-2016, 09:55 AM)DeathBringer Wrote: [ -> ]Try to flash my mod.
After flashing go to BIOS and do Load Defaults.
Reboot and make & post new screenshot of regedit with expanded key HKEY_LOCAL_MACHINE\HARDWARE\DESCRIPTION\System\CentralProcessor\0
I´ll try that at the weekend, i´m not home right now. I´ll return asap. Tks
(11-22-2016, 09:55 AM)DeathBringer Wrote: [ -> ]Try to flash my mod.
After flashing go to BIOS and do Load Defaults.
Reboot and make & post new screenshot of regedit with expanded key HKEY_LOCAL_MACHINE\HARDWARE\DESCRIPTION\System\CentralProcessor\0
Deathbringer,
I flashed the bios, but still running at half speed. Attached is the screenshot you´ve asked.
tks.
(12-01-2016, 05:09 PM)lfcout Wrote: [ -> ]but still running at half speed.
Did you
Load Defaults in BIOS after flashing?
Make a screenshot of
HWmonitor with full CPU load.
Make
CPU-Z TXT Report and post "Processors Information" section from it.
(12-01-2016, 11:54 PM)DeathBringer Wrote: [ -> ] (12-01-2016, 05:09 PM)lfcout Wrote: [ -> ]but still running at half speed.
Did you Load Defaults in BIOS after flashing?
Make a screenshot of HWmonitor with full CPU load.
Make CPU-Z TXT Report and post "Processors Information" section from it.
I tried to flash twice with gigabyte @bios software. I´ve loaded both optimized and fail safe defaults and cleared bios fisically on board jumper.
Attached are the prints you´ve asked.
tks a lot!
Thx.
Well. I need "Thread dumps" section from CPU-Z TXT Report too.
All seem be OK, but MSR 0x00000198 is wrong.
I'll try to correct.
