(04-18-2020, 08:01 AM)DeathBringer Wrote: [ -> ]Update all.
I really appreciate your time and expertise.
It says every (
BMC, BIOS, ME, FRUSDR) updated and completed. Remove Flash drive and press front button.
I power off, then I power on then it freeze.
then it went back to 02.06.0006
Also, I tried
AFUDOS and AFUWINx64 and both have the same error 46
Do I have to change any jumper setting on motherboard? Here is the instruction page.
Should I try again using this instructions?
https://www.intel.com/content/www/us/en/...stems.html
I am confuse with Step #5:
"In order to downgrade the version R01.01.0020, we can do it by version, which means that we need to downgrade to version R01.01.0024, then to version R01.01.0022, then to version R01.01.0021, and finally to the needed one R01.01.0020."
Does it mean I have to downgrade one version at a time ?
or can I jump from 02.06.0006 to 01.08.0003 right away?
(04-18-2020, 08:57 AM)JM55 Wrote: [ -> ]or can I jump from 02.06.0006 to 01.08.0003 right away?
Try it.
Your first task to do it yourself - the installation
01.08.03. At least BIOS & ME.
You need
ME Firmware Force Update Mode –
Enabled
Second task - selection of a suitable tool for read & write BIOS.
Download
SPS FPT 1.2.24.3.
Run
spsFPT in DOS:
spsFPT -bios -d bios.rom
or in Windows:
spsFPTW64 -bios -d bios.rom
OK.
Now test writing back result file by spsFPT in DOS:
spsFPT -bios -f bios.rom
or in Windows:
spsFPTW64 -bios -f bios.rom
And test your ES Xeon with this version of BIOS.
(04-18-2020, 02:57 PM)DeathBringer Wrote: [ -> ]OK.
Now test writing back result file by spsFPT in DOS:
spsFPT -bios -f bios.rom
or in Windows:
spsFPTW64 -bios -f bios.rom
And test your ES Xeon with this version of BIOS.
It didn't allow me flash back the bios.rom I got earlier.
Here is the error on Windows and DOS.
[
attachment=18616]
The xeon ES gives fatal error. Amber solid light on board status LED. It just stuck on the first AMI Version screen.
(04-18-2020, 03:22 PM)JM55 Wrote: [ -> ]The xeon ES gives fatal error. Amber solid light on board status LED. It just stuck on the first AMI Version screen.
Please show a photo of the screen.
Good.
Now download
prr2
Unpack & copy it to DOS USB stick. Boot in DOS and run:
prr2
spsFPT -bios -f bios.rom
Show results.