Foxconn 865G7MF Pinmodded Xeon Support

[DeathBringer]

Hi. Is it possible to get the E5800 processor to work on this board by adding microcode to the BIOS?

No way.

[KSM74]

No way.

I have reason to doubt this assertion, but I cannot prove or disprove it - https://forums.tomshardware.com/threads/...d.3542666/

[DeathBringer]

This motherboard has old VRM of without support of Conroe and Wolfdale.

[KSM74]

Just for fun. You can port codes 10677 and 1067a from the board using the link below. As you did in "my mod" file. If that doesn't work, I'll give the board to the owner of a Pentium D.
https://theretroweb.com/motherboards/s/foxconn-g31mxp

[KSM74]

I made a pin mod like on the website https://www.vogons.org/viewtopic.php?t=98060. I'm trying to enter codes, but the CBROM195 doesn't write them in the right place in BIOS.The motherboard starts with the C100 code and then won't boot.
What am I doing wrong?



Information from CBROM on the upgraded BIOS


Original BIOS

[DeathBringer]

What am I doing wrong?

Adding microcode doesn't add support for new CPUs.

[KSM74]

What am I doing wrong?

Adding microcode doesn't add support for new CPUs.

OK, that board's gone in the trash. E5800 found himself a new girlfriend - Asrock 775i65G R3.0.