[Request] HP/Compaq NX9600/zd8000/X6000 - Add Cedar Mill/65nm Pentium 4 MC

[k24a1]

Alright, I've done some testing. Either with or without J2 isolated, the computer won't fully POST. It sounds like it's going to boot (fan spins up and then back down), but the caps/num lock lights don't blink and the display doesn't come up. I'm sure it recognizes the chip, but it doesn't have the sufficient code to fully start the computer.

[Antinomy]

Too bad there's no POST card so you can check where it stops. It's possible, J2 is not the only required pin for modification. Still, I believe that BIOS is not vital for Cedar Mill to boot.

[k24a1]

Too bad there's no POST card so you can check where it stops. It's possible, J2 is not the only required pin for modification. Still, I believe that BIOS is not vital for Cedar Mill to boot.

Do you happen to know about any other modifications? I have a zd8000 I can test with now.