General method to remove whitelist from Insyde BIOS

[traitor]

File at this Link is absent.
Please help me. Very needed.

Reload !!!

Already found:

HP Pavilion dv8 F.25 whitelist removed

HP_Pavilion_dv8_F.25_sp49106_7001F25_NWL.rar

[Vignesh0025]

Please someone remove whitelist and unlock advanced tab for this bios InsydeH20 F.34 of HP Pavilion 15 n012tx .


http://ftp.hp.com/pub/softpaq/sp64501-65000/sp64555.exe

[cdjr]

File at this Link is absent.
Please help me. Very needed.

Reload !!!

Already found:

HP Pavilion dv8 F.25 whitelist removed

HP_Pavilion_dv8_F.25_sp49106_7001F25_NWL.rar

Help friends... I need this file too... Can anyone help us?

[Jayloki1969]

Hi guys,

Anyone have a modded bios for an HP G62-228CA laptop to allow any WLAN chip? (whitelist)

http://ftp.hp.com/pub/softpaq/sp52501-53000/sp52598.exe

Hoping someone can remove the wlan whitelist in there.

Thanks for any help folks!!

[unnamed93]

how to make lenovo z510?

[BDMaster]

Using an SPI Programmer + Clip :

https://www.bios-mods.com/forum/Thread-R...5#pid74575

Let me know
Regards

P.S. buy the tools and I will help You !

[usiex]

How to remove whiltelist from hp elitebook 2540p.If this possible?
I read more forums but no answer how to do it.
I attache my dump bios reading programmers.
Thanks to help

[Serdgi]

Hello!
Motherboard Z77- Stinger. Bios V1.24.
Intel Core I7 3770T. Do not run the motherboard module Killer Wireless-N 1103 Dual Band. Error code - 92. Can you help me?
Have a nice day!

[zaidap]

10. Open a command prompt and navigate to where you saved the file and type debug something.com, you should get a '-' prompt, type u and hit enter and you should see something like this. See step3.jpg.

The first column is memory addresses, the 2nd column is instruction bytes and the rest are Intel mnemonics.
11. Now we need some elementary assembly skills to find what we are looking for. Debug will show the mnemonics for the instructions. Debug doesn't handle 386 instructions well so you may see a few ??? but we should be able to find what we need. Look for a test al,al followed by a jnz {address}. The unassemble should have addresses on the left and they should correspond to the addresses in the debug so you can then -u {address} to see what happens at the jump to locations. See step4.jpg.

12. Now that we know what to change write down a about 6 or so of the bytes ending with the 75 and the following byte (27 in the step 4 example) and go back to WinHex and from the start of our program (the «55 8b ec» bytes) search for the bytes you recorded. Make sure everything around matches your debug window and replace 75 (JNZ short) with eb (JMP short). eb is an unconditional jump and will exit the routine so we don't get to the infinite loop. See step5.jpg.

Mark

I have a problem, when i get to step 10 and its time to do the
"debug 'something'.com" it says "insufficient memory"... Then i get the "-" prompt and i can still do the "u" but i keep searching and searching and i get everything but test and jnz...



Also, if possiable, could anyone mod my bios? my computer is an hp g50-118NR and i want to remove the whitelist.. Heres the post i made requesting for help: http://www.bios-mods.com/forum/Thread-Re...val-hp-g50

40Mb com file???

real .com file has size limit of 64Kb and debug uses segmented memory in 64Kb sized segments.

Try reducing the selection before saving hi.com to 2 or 3 pages only not the whole bios.

When you end up with a .com file with less than 64Kb debug will load it properly.

Nice day.
Camilo.

Edit: This is the sencond BIOS i mod this days, i will put them in my mediafire folder. You can find yours there. Nice day

Folder with Modded Bios

Hi!
I hope you understand my english.

I´m trying to do make my bios whitelist.
My notebook is a HP G42-283LA

""""I have a problem, when i get to step 10 and its time to do the "debug 'something'.com" .... but i keep searching and searching and i get everything but test and jnz... """"

i can´t find these words..... test jnz

I try with one modified by camilo sp52074_NWL_ByCamiloml

The notebook flash WITH this bios . Restart Works fine , apparently .
Then suddenly some attempt, no more video.....

then flash with a programmer, original bios, and resureccts....

Please help me!!!

[Funnytoto]

Hello, can i whitelist removal with a Sony VAIO VPCEH3K1E ? How can i do that, i'm a begginer :'( It's for an eGPU