8 hours ago
Hi everyone,
I’m looking for some help adding C3-stepping CPU support to my Acer Aspire X3200 motherboard so it can POST with an Athlon II X2 260 ( ADX260OCK23GM).
Hardware & BIOS Details
I already extracted the NCPUCODE.BIN microcode module from a Gigabyte nForce 720a donor BIOS (M85MUS2H) and injected it into the Acer R01-B0 ROM using CBROM
. However, the board still hangs with continuous fan spin and no POST/beeps, which points to the older 2009 AGESA block inside the main system binary failing to initialize the C3-stepping memory controller/HT link.
Attached Files (in ZIP)
Thanks in advance!
I’m looking for some help adding C3-stepping CPU support to my Acer Aspire X3200 motherboard so it can POST with an Athlon II X2 260 ( ADX260OCK23GM).
Hardware & BIOS Details
- System / Motherboard: Acer Aspire X3200 (DA078L/ Boxer)
- Chipset: NVIDIA nForce 720a / MCP78PV (AM2+ socket, DDR2)
- BIOS Type: Phoenix-Award BIOS
- Current Official BIOS: R01-B0(final official release)
- Target CPU: AMD Athlon II X2 260 ( ADX260OCK23GM , Regor C3 stepping, 65W)
- Hardware Programmer Available: Yes — I have a Raspberry Pi Pico running serprog
(flashrom) and a verified hardware dump of the stock SPI flash chip, so I can safely test and recover without bricking risk.
I already extracted the NCPUCODE.BIN microcode module from a Gigabyte nForce 720a donor BIOS (M85MUS2H) and injected it into the Acer R01-B0 ROM using CBROM
. However, the board still hangs with continuous fan spin and no POST/beeps, which points to the older 2009 AGESA block inside the main system binary failing to initialize the C3-stepping memory controller/HT link.
Attached Files (in ZIP)
- backup_stock.bin
— Verified hardware SPI dump of the original Acer R01-B0 BIOS.
- modded_acer_ncpu.bin — My current attempt with the Gigabyte NCPUCODE.BIN injected.
- gigabyte_donor.bin — The donor Gigabyte nForce 720a BIOS used for the microcode.
Thanks in advance!






