Forum RSS Feed Follow @ Twitter Follow On Facebook

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[-]
Welcome
You have to register before you can post on our site.

Username:


Password:





[-]
Latest Threads
[REQUEST] Sony Vaio VPCEH & VPCEJ series...
Last Post: angelheart
Today 03:57 PM
» Replies: 250
» Views: 234615
an adding of the ASUS CT-479 support for...
Last Post: DeathBringer
Today 12:15 PM
» Replies: 5
» Views: 238
[REQUEST] Dell Inspiron 545 BIOS Unlock
Last Post: irq5
Yesterday 03:24 PM
» Replies: 20
» Views: 14329
[REQUEST] MSI X79A-GD65 - Add support fo...
Last Post: iaval
Yesterday 12:11 PM
» Replies: 0
» Views: 54
HP Zbook G7 POST password removal
Last Post: Kruba
Yesterday 06:56 AM
» Replies: 0
» Views: 88
[Request] Acer Aspire X3200 (DA078L / nF...
Last Post: Canhao
Yesterday 04:16 AM
» Replies: 6
» Views: 155
[REQUEST] HP EliteBook 840 G3 Whitelist ...
Last Post: Max Peet
11-16-2026 03:09 PM
» Replies: 2
» Views: 5976
[REQUEST] Lenovo G710 BIOS Whitelist Rem...
Last Post: Znixz12
11-16-2026 02:30 PM
» Replies: 508
» Views: 346141
[REQUEST] Dell Wyse 3040: CSM enable for...
Last Post: mm400
11-16-2026 12:00 PM
» Replies: 3
» Views: 4136
Thinkpad e460 whitelist removal
Last Post: JohnBen
11-15-2026 10:18 PM
» Replies: 0
» Views: 119
[REQUEST] Lenovo G580 (5ECNxxWW) Whiteli...
Last Post: Alex'sShtormXXX
11-15-2026 01:40 PM
» Replies: 1738
» Views: 1252785
[REQUEST] Lenovo Ideapad Z710 (7FCNxxWW)...
Last Post: Dudu2002
11-15-2026 01:28 PM
» Replies: 232
» Views: 217527
[Unlocked AHCI, sp53872] HP Pavilion g6-...
Last Post: bryan26i
11-15-2026 01:13 AM
» Replies: 14
» Views: 22383
[REQUEST] Lenovo IdeaPad Gaming 3 15IMH0...
Last Post: leoramoners
11-12-2026 07:09 AM
» Replies: 67
» Views: 62090
[REQUEST]
Last Post: Skimpa
11-10-2026 04:20 PM
» Replies: 0
» Views: 389
[REQUEST] Sony VAIO SVE151 & SVE171 Seri...
Last Post: ryan13213545345
11-09-2026 05:36 PM
» Replies: 61
» Views: 54194
Lenovo M90p Xeon Support + Question
Last Post: bmb021
11-08-2026 12:23 PM
» Replies: 23
» Views: 6021
[REQUEST] Acer Nitro 5 AN515-54 BIOS Unl...
Last Post: Dudu2002
11-08-2026 10:13 AM
» Replies: 150
» Views: 140087
[REQUEST] Lenovo IdeaPad S210 (80CNxxWW)...
Last Post: Dudu2002
11-08-2026 10:12 AM
» Replies: 46
» Views: 32124
[REQUEST] HP Elitebook 8440p Whitelist R...
Last Post: mooms2
11-07-2026 01:17 PM
» Replies: 76
» Views: 68260

DELL Precision 690 microcode update
#41
X5355 (SLAEG) must work on your motherboard. BIOS has microcode for them. Give me links to failed attempts to boot these CPU on your motherboard.
Xeon 5400-Series are not supported!
find
quote
#42
(02-12-2016, 09:38 AM)DeathBringer Wrote: X5355 (SLAEG) must work on your motherboard. BIOS has microcode for them. Give me links to failed attempts to boot these CPU on your motherboard.
Xeon 5400-Series are not supported!

OK so I'll get them and see if they work. Thanks for the help, I was worried from what a couple people said that I wouldn't be able to use them.
find
quote
#43
Any luck with adding E54xx Xeon support to the A08 Dell BIOS?
I have a E5420 specifically.
find
quote
#44
No, Xeon 5400-series aren't supported by hardware.
find
quote
#45
(02-12-2016, 09:38 AM)DeathBringer Wrote: X5355 (SLAEG) must work on your motherboard. BIOS has microcode for them. Give me links to failed attempts to boot these CPU on your motherboard.
Xeon 5400-Series are not supported!

A link to someone talking about it can be found in the description of this Youtube video, and some other Dell forum that I'll have to dig up.
Link: https://www.youtube.com/watch?v=yk_eRS8C-L0

EDIT: Here is the Dell forum thread I was talking about: http://en.community.dell.com/what-do-i-b...?pi41074=2
Hopefully that helps.
find
quote
#46
OK. It's usefull
Quote:Posted by SpeedStep on 12 Oct 2011 8:58 AM
The Information seems to vary almost YMMV

DT029 Earliest 690 motherboard revision, not quad capable. (rejects Xeon E5310)
F9394 Revised 690 motherboard,not quad capable. (rejects Xeon E5310)
MY171 Revised 690 motherboard,quad capable.

Look for a sticker on the MB with a code like:
CN-ODT029-13740-67S-0044
The version is in the secound Part -ODT029 in this case.

The trick to getting some upgrades to work was to remove the button cell battery on the motherboard for a minute or so and then replace it. When you power on the machine you will be asked to go into setup and set the date and time. After doing this the machine would boot with A06.
The problem is that if you ever remove the power cable, or switch off at the wall, then your 690 won’t boot again and it will give the “Incompatible processor detected!” message again.
So while I had a working machine I downloaded the A01 version of the BIOS from ftp.us.dell.com and installed it. After this my machine is fully functional again.

I don’t have the time at the moment to do a test of all BIOS versions between A01 and A06 to see where the problem starts.
XEON 5410 tried with biosA07 and MY171. Not working.
XEON 5420 tried will biosA06 and DT029. Not working.
For those of you that don't know, you can get a both a DT029 and F9394 motherboard 'working' with quad-core CPUs.

For F9394 motherboards: Any BIOS revision can be used, when you get the "incompatible processor detected!" message unplug the machine from the mains and remove the clock battery. Wait for at least 30 seconds before re-inserting the battery and then restore the power. The machine will operate normally up until the point where it is unplugged from the mains, at which point you will have to repeat the procedure.

For DT029 motherboards: The same as above except you must be running BIOS revision A01 (A02 is a possibility but untested) or lower. If you only have a quad-core chip you will need to find a dual-core CPU to downgrade the machine with, the battery removal trick will not work if you have upgraded the BIOS past A02.
Quote:Posted by King George on 17 Jun 2013 4:31 AM
THIS IS THE ANSWER! Speedstep's answer is only partially correct. There are two revisions of the MY171 motherboard. Rev A01 indeed does not work with any quad cores with BIOS between A02 AND A08. I tried everyone. And I got the incompatible CPU message every time. When I attempted to use BIOS A01, the flash did not go through properly and my mother board was bricked! This does not happen to everyone. I was just lucky that day. I am not a quitter, so I went online and bought another MY171 mobo from txcesssurplus.

This time, the company sent me a Rev A02 MY171 mobo. I replaced the old REV A01 MY171 board, put in my dual e5345, and the CPUs work just fine under bios A07. THIS IS THE ANSWER. This is why some people with MY171 boards get the quads to work and others do not. I SUSPECT EVERY ONE WITH PROPERLY WORKING QUADS IN THE MY171 BOARD HAS MOBO REV A02 AND EVERYONE WHO HAS HAD NO/LIMITED SUCCESS WITH QUADS HAS MOBO MY171 REV A01.

I do not know about the F9394 or the DT029 as I never used one, but I suppose Speedstep's post is accurate about them and they do not work properly with e5300 series cpu. Buying a REV A02 MY171 mobo from ebay is difficult as no one lists the mobo revision number. I got lucky really. Ask the seller to look at the revision number before you buy it, or just buy one from the seller I mentioned above and hope for the best.

I am in 8-core heaven now and will make a lot of money with this computer starting this weekend doing video editing and rendering. I spent a total of $120 on it, so I suppose it was worth the hassle. I still hate dell and am very angry they did not post this info in their description of this product.

The problem is “Incompatible processor detected!” message. May be it's only BIOS limitation like in Dell Optiplex GX520/620.
But to check it you must have Xeon 5300-series.
find
quote
#47
I found code in module 0B_9.ROM that verify CPUID and set error status to 0x16 (Alert! Incompatible processor detected.).
Code:
9FD8 push eax 9FDA mov eax, 1 9FE0 cpuid 9FE2 and ax, 0FFF0h 9FE5 cmp ax, 0F60h ; Dempsey 9FE8 jz short 0A00Ah 9FEA cmp ax, 6F0h ; Woodcrest & Clovertown 9FED jnz short 0A00Ah 9FEF call sub_AE1D ; reading byte in 0F000h:4D73h 9FF2 cmp al, 3 9FF4 jb short 0A00Ah 9FF6 mov al, 50h ; 'P' 9FF8 call 0F000h:0F18Ch ; reading CMOS memory 9FFD cmp al, 30h ; '0' ; 9FFF jnb short 0A00Ah A001 mov cx, 16h ; set error status to 16h A004 call sub_B7A5 A007 jmp 732Bh ; jump to halt state A00A pop eax ; continued normal
The segment 0F000h is the concatenation of 01_2.ROM and 02_3.ROM modules
Download SYMCMOS and run in native(!) DOS:
SYMCMOS –v2 –lOLD.TXT
Post file old.txt
Code:
usage: SYMCMOS <options> -? show this help -D program BIOS default values -S[filename] produce symbolic report file -L[filename] produce literal report file -U[filename] update CMOS using script file -C[filename] combine build files -F[filename] use combine file for report -V0 disable logging -V1 enable error logging (default) -V2 enable verbose logging -V3 No CMOS update and verbose logging
find
quote
#48
(02-12-2016, 12:50 PM)sbergeron Wrote:
(02-12-2016, 09:38 AM)DeathBringer Wrote: X5355 (SLAEG) must work on your motherboard. BIOS has microcode for them. Give me links to failed attempts to boot these CPU on your motherboard.
Xeon 5400-Series are not supported!

OK so I'll get them and see if they work. Thanks for the help, I was worried from what a couple people said that I wouldn't be able to use them.

sbergeron, did you ever try out the Xeon 5300 series processors with your Precision 690 MY171 rev A00 mobo and A08 bion?? 

I am in the same boat as you with the hardware and bios setup.  Looking to run quad cores is possible.  Thanks in advance!
find
quote
#49
Did you tried to boot with Xeon 5300 series? Please tell S-spec of it.
And I need the result of SYMCMOS.
find
quote
#50
(05-01-2016, 10:35 AM)DeathBringer Wrote: Did you tried to boot with Xeon 5300 series? Please tell S-spec of it.
And I need the result of SYMCMOS.
I didnt purchase the processors yet.  Like the original post, I wanted some verification of the compatibility before buying.  After looking a a bunch of 5300 series processors on eBay, "SLAEG" seems to be a popular sspec.  Is there an sspec I should lean towards or ones I should stay away from?
find
quote


Forum Jump:


Users browsing this thread: 2 Guest(s)