Login

***DeathBringer*** · 03-26-2017, 01:17 PM

It's rather strange...
Have you a hardware programmer (like CH341A)?

danil771 · 03-26-2017, 01:17 PM

(03-26-2017, 01:17 PM)DeathBringer Wrote: It's rather strange...
Have you a hardware programmer (like CH341A)?

no

***DeathBringer*** · 03-26-2017, 01:21 PM

Try remove CMOS battery for 10 min.
Then enter in BIOS and load defaults values.
Save and reboot
Any changes with SSE 4.1 after it?

danil771 · 03-26-2017, 02:01 PM

(03-26-2017, 01:21 PM)DeathBringer Wrote: Try remove CMOS battery for 10 min.
Then enter in BIOS and load defaults values.
Save and reboot
Any changes with SSE 4.1 after it?

Done
Results:
- there are no sse4.1
- we solved problem with cpu fan speed - it is minimal, but before this manipulation it was max.

***DeathBringer*** · 03-26-2017, 02:05 PM

Try to flash BIOS by Recovery BIOS Update->Recovery with USB device. To locate BIOS Configuration Jumper use motherboard's manual.
After successful flashing make new screenshot of regedit.

danil771 · (This post was last modified: 03-27-2017, 02:23 AM by danil771.)

(03-26-2017, 02:05 PM)DeathBringer Wrote: Try to flash BIOS by Recovery BIOS Update->Recovery with USB device. To locate BIOS Configuration Jumper use motherboard's manual.
After successful flashing make new screenshot of regedit.

It's strange, but i cant recovery it by USB.
CPUs red leds are lightning on the board, maybe i must to install the second cpu?

***DeathBringer*** · 03-27-2017, 10:58 AM

Try Recovery with CD-ROM

danil771 · 03-28-2017, 07:10 AM

(03-27-2017, 10:58 AM)DeathBringer Wrote: Try Recovery with CD-ROM

I have done Recovery to 1353 with USB only after installing the second cpu.

***DeathBringer*** · 03-28-2017, 11:36 AM

Bad news. Injected microcode (by CHECKUP7) wasn't overwritten. Sad

danil771 · 03-28-2017, 12:03 PM

I saw.
Maybe i can do someting by hex editor?

Login
Username:
Password:	Lost Password?
	Remember me