Made Progress with GA-MA69G-S3H. Need help though.

[oricaluv]

Been modding the F8e Beta BIOS for this board for the last day or so. Didn't want to bother anyone with this but here goes... Google and this site helped alot with updating the NCPUCODE.BIN and the AGESA, and the ma-ga69g-s3h did take the flash and the board did post. Processor was successfully identified as a Phenom II x6 1090t. But for some reason the board is now only seeing 128m of ram out of 6gb. I swapped out the mixed and matched ram for 4 sticks of Ballistix DDR2 1066 and noticed that only the 1st and 3rd slots were lighting up or working. Went ahead and added MEMINIT.BIN to the BIOS and got all 4 sticks working, but still only 128m of it being seen by the BIOS. The machine will attempt to boot Windows 7 64 bit but will BSOD with a single line of code on the screen till I reset it or shut it down. I noticed with the modded BIOS that if I put a Phenom x4 9850 in the machine it shows the same behavior. I know I'm doing something wrong here guys, please help.

Tools I used...
NCPUCODE.BIN from the 1st post here: http://www.bios-mods.com/forum/Thread-Ho...-Microcode

AGESA 3.7.0.0 AND 3.7.0.1: From the download section on this site.

MEMINIT.BIN from a donor BIOS (bios_ga-ma790fxt-ud5p_f8n) This board showed support for the cpu I was aiming for...

CBROM 182, 195 , 198: downloaded from this site.

Please help me figure this out. All I wanted was to be able to run the 1090t on this board. No idea if the board supports dual power planes.

Here is the unmodded BIOS: http://www.mediafire.com/?pkb608u0vyfx19s