OptiPlex 360 380 760 780 960 Xeon LGA 771 E0 1067A Microcode

[Repping]

When i use the the extra command /forceit

Then this happens.
'Erasing 100%
Writing 100%
Verifying 0x2000 bytes at address 0xFFE16000. ... 01% done
ERROR ! - Miscompare at MMIO address 0xFFE17E48
NVRAM data = 0x87, Image data = 0x52.

### ERROR ###. Direct Update Program Path Error
An error was encountered comparing the NVRAM data to the ROM image

This message is displayed with all the mods if i use the extra command /forceit


My computur has 8gb of ram installed.
Should i pit the original amount of ram back in?

Regards,

Richard

[DeathBringer]

Can you flash original A05 version without errors?

[Repping]

No I was only able to load an original A07 without errors.

Any other version gives an error saying it fails several check safety checks.
And if i use the /forceit command then I get the error as discribed previously.

Should i maybe remove the cmos battery to reset before flashing?

[DeathBringer]

Yes. Try it,
How to Perform a BIOS or CMOS Reset and/or Clear the NVRAM on your Dell System
Try to flash Initial Release of BIOS.

[Repping]

Failed again.

I have reset the cmos with the jumper and battery option tried loading initial release of bios and it gave a failed consistancy check.
Like before.

I think mine is not gonna do the trick... ?

[DeathBringer]

Have you any supported CPU?

[Repping]

This with the original CPU installed.

I can only flash with the latest A07 from dell. Then no error occurs ..

[DeathBringer]

Try with to change to your Xeon and to flash Initial Release of BIOS from DOS.

[Repping]

Apparently there arae sone slight version differences in dell morherboards.
Ill try and get the right A05 option from Dell and see what happens.
Cheers Richard.

Ill let you know

[DeathBringer]

Post the screenshot of third (Mainboard) tab of CPU-Z.
And give me the link to "right" BIOS.