Forum RSS Feed Follow @ Twitter Follow On Facebook

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[-]
Welcome
You have to register before you can post on our site.

Username:


Password:





[-]
Latest Threads
an adding of the ASUS CT-479 support for...
Last Post: DeathBringer
Today 12:15 PM
» Replies: 5
» Views: 231
[REQUEST] Dell Inspiron 545 BIOS Unlock
Last Post: irq5
Yesterday 03:24 PM
» Replies: 20
» Views: 14324
[REQUEST] MSI X79A-GD65 - Add support fo...
Last Post: iaval
Yesterday 12:11 PM
» Replies: 0
» Views: 49
HP Zbook G7 POST password removal
Last Post: Kruba
Yesterday 06:56 AM
» Replies: 0
» Views: 80
[Request] Acer Aspire X3200 (DA078L / nF...
Last Post: Canhao
Yesterday 04:16 AM
» Replies: 6
» Views: 153
[REQUEST] HP EliteBook 840 G3 Whitelist ...
Last Post: Max Peet
11-16-2026 03:09 PM
» Replies: 2
» Views: 5970
[REQUEST] Lenovo G710 BIOS Whitelist Rem...
Last Post: Znixz12
11-16-2026 02:30 PM
» Replies: 508
» Views: 346101
[REQUEST] Dell Wyse 3040: CSM enable for...
Last Post: mm400
11-16-2026 12:00 PM
» Replies: 3
» Views: 4129
Thinkpad e460 whitelist removal
Last Post: JohnBen
11-15-2026 10:18 PM
» Replies: 0
» Views: 116
[REQUEST] Lenovo G580 (5ECNxxWW) Whiteli...
Last Post: Alex'sShtormXXX
11-15-2026 01:40 PM
» Replies: 1738
» Views: 1252717
[REQUEST] Lenovo Ideapad Z710 (7FCNxxWW)...
Last Post: Dudu2002
11-15-2026 01:28 PM
» Replies: 232
» Views: 217509
[Unlocked AHCI, sp53872] HP Pavilion g6-...
Last Post: bryan26i
11-15-2026 01:13 AM
» Replies: 14
» Views: 22376
[REQUEST] Lenovo IdeaPad Gaming 3 15IMH0...
Last Post: leoramoners
11-12-2026 07:09 AM
» Replies: 67
» Views: 62083
[REQUEST]
Last Post: Skimpa
11-10-2026 04:20 PM
» Replies: 0
» Views: 385
[REQUEST] Sony VAIO SVE151 & SVE171 Seri...
Last Post: ryan13213545345
11-09-2026 05:36 PM
» Replies: 61
» Views: 54176
Lenovo M90p Xeon Support + Question
Last Post: bmb021
11-08-2026 12:23 PM
» Replies: 23
» Views: 6007
[REQUEST] Acer Nitro 5 AN515-54 BIOS Unl...
Last Post: Dudu2002
11-08-2026 10:13 AM
» Replies: 150
» Views: 140067
[REQUEST] Lenovo IdeaPad S210 (80CNxxWW)...
Last Post: Dudu2002
11-08-2026 10:12 AM
» Replies: 46
» Views: 32118
[REQUEST] HP Elitebook 8440p Whitelist R...
Last Post: mooms2
11-07-2026 01:17 PM
» Replies: 76
» Views: 68239
Lenovo M90q Gen 3 LGA1700 Support
Last Post: DeathBringer
11-06-2026 01:41 AM
» Replies: 3
» Views: 726

Supermicro X9DR3-LN4F+ intel qdnr e5 2670v2 es
#11
ES CPU aren't required any microcode to boot up. Only the special executable code in BIOS is needed.
Use external graphics card.
find
quote
#12
I've found BIOS version R 2.0 (X9DR3P3_111.zip)
find
quote
#13
1. Flash it
2. Turn off and disconnect power cable.
3. Remove CMOS-battery
4. Install new CPU
5. Set BMC jumper to Disabled
6. Set VGA jumper to Disabled
7. Connect power cable, power up & shutdown.
8. Disconnect power cable
9. Set VGA jumper to Enabled
10. Install CMOS-battery.
11. Connect power cable & power up
find
quote
#14
Supermicro MB page says that for E5-2600 v2 series Bios revision of 3.0 or above is required (https://www.supermicro.com/products/moth...-LN4F_.cfm).

Is it okay to flash R2.0 anyway for running V2 ES CPU ? Or should I try the above procedure with any other previously given Bios Revisions greater than or equal to R 3.0 ?
find
quote
#15
(01-15-2017, 12:28 PM)rathi Wrote: Supermicro MB page says that for E5-2600 v2 series Bios revision of 3.0 or above is required
I've looked inside BIOS R 2.0, so it's first released BIOS for this motherboard with Ivy Bridge EP core support
find
quote
#16
Followed your post copybook style but still could not bring this up.
Same behavior, No beeps (with E5 v1 series it gives beep on start of boot), no display, no boot.

What should we do now?
find
quote
#17
Last chance is using a simple external graphics card.
Install it in last(!) PCI-E slot (#6) and set VGA jumper to Disabled
find
quote
#18
I did the above using the PCIe external graphics card since you suggested in last to last post. I will try as you said to install it in last CPU slot with VGA Jumper disabled.
Interestingly I found this on internet (ebay) for the said CPU in question :

http://i.ebayimg.com/images/g/xt4AAOSwfY...s-l500.jpg
find
quote
#19
Done everything (Instead of slot 6 which is for CPU2, I inserted it in slot 3 which is last PCIe for CPU1) and still no luck.
Also tried with R3.0 again but without success.
It is strange that if I looks via IPMI Sensor Readings, it gives clear indication to voltage 0.976 Volts along with its threshholds (min/max volts).

Isn't this means that the Board is able to recognize CPU and read its voltage parameters? At the same time temp sensors says CPU 1 "Not present" in the system (which means it cannot read temp of the CPU).
I observed that the CPU heat sync gets hot on touching after some time which indicate: I don't know what. But at the same time no Beeps, no Display and no Boot.

Tried all these versions now : 2.0, 3.0, 3.0a, 3.0b, 3.2 without success. I have version 1.1a as well.

Any other suggestions? anyone? for the processor detailed here : http://i.ebayimg.com/images/g/xt4AAOSwfY...s-l500.jpg

Thanks in Advance!
find
quote
#20
I just removed all RAM from system and still no beeps, no display, no post. I expected at least beeps for no RAM? which could mean that it stops even before reaching the state to test RAM etc.
find
quote


Forum Jump:


Users browsing this thread: 1 Guest(s)