Login

lion_sergey · 07-15-2021, 01:30 PM

Did. Does not work. You can go to the bios, but then a black screen.

***DeathBringer*** · 07-15-2021, 01:44 PM

So it's not microcode problem.
Try to flash previous official BIOS: v3636 and v3810.

lion_sergey · (This post was last modified: 07-16-2021, 10:49 AM by lion_sergey.)

3810 also tried. The result is a black screen. It works only on the firmware from genius239, but when loading it gives "02f0 CPU ID: FB No Microcode Update Loaded for Alternate Processor", and the computer keeps asking f1 to resume or f2 setup at startup. After pressing F1, windows loads and works without problems.

***DeathBringer*** · 07-16-2021, 11:23 AM

(07-16-2021, 10:49 AM)lion_sergey Wrote: It works only on the firmware from genius239, but when loading it gives "02f0 CPU ID: FB No Microcode Update Loaded for Alternate Processor"

I think it say 02f0 CPU ID: FA No Microcode Update Loaded for Alternate Processor
Try v3636

lion_sergey · 07-16-2021, 11:45 AM

Yes, I was wrong. Does flsah 3636 make sense? I'm already thinking of ordering a new processor. Which one do you recommend? The GL40 chip.

***DeathBringer*** · (This post was last modified: 07-16-2021, 01:21 PM by DeathBringer.)

(07-16-2021, 11:45 AM)lion_sergey Wrote: Does flash 3636 make sense?

Yes.

(07-16-2021, 11:45 AM)lion_sergey Wrote: I'm already thinking of ordering a new processor. Which one do you recommend? The GL40 chip.

T8100, T8300, T9300 and T9500 are recommended.

lion_sergey · 07-17-2021, 10:49 AM

Thank you for your help! I ordered a T8300. I will try to put it on.

lion_sergey · 07-31-2021, 10:40 AM

Today I installed the T8300. The processor started up without any problems. Thank you for your help!

Login
Username:
Password:	Lost Password?
	Remember me