Fujitsu Siemens Amilo D7850 Bios mod for fan values

[Etabeta]

Hello everyone !! i just updated the bios of my old amilo notebook..

it was necessary because the cpu fan was always at high speed and i had to put a regulator inside..on the wire !! Anyway the cpu temp was always under 40..

But now the new bios sets the initial speed to off... the temp always goes to 55 then the fan starts... at a noisy level.. and this happens 2-3 times a minute....

i am asking your help for setting a initial value of the cpu fan at a low rpm value..
so the temp will be ok and the noise too..

it is a pc i had in "heritage" by ew weeks.. i remember it had a fan for chipset too..
it has in fact..i opened and cleaned it !!
And it seems to be disabled too with the new bios...

If it is possible to set both at the minimum rpm..
dont know how it works..if there are fixed rpms..or what !!

I will post the bios image if somebody can help !! tx !!
paolo

[Etabeta]

obviously i did not save the original bios 1.02c ..
the 1.04 is the same as the last one 1.07c