Hello guys, I have this laptop and the cpu is kept quite cool. But the gpu is overcooking, any way to solve this i would like to be able to set when the fan will speed up. I would even like the option to set it to maximum.
Posts: 1,219
Threads: 62
Joined: Mar 2013
Reputation:
45
As there is only one fan which is speeding only when cpu is under load ( i early made constant 5volt income to the fan)that would be the needed regulation. If you could open it up that would be awsome .
Posts: 1,219
Threads: 62
Joined: Mar 2013
Reputation:
45
Hello, yes Sir. I tried few times to learn the process of moding the Bios because I felt that it could be done, but no one did it.
Yes only 1 fan, which will start only if the CPU is over 53C, and will speed up only if the CPU is under load. Most of the time the CPU is under 60C and GPU over 75C (which is by the way killing it).
Oh boy thank you a lot, I will try it when you are done and report back the same minute .
Posts: 1,219
Threads: 62
Joined: Mar 2013
Reputation:
45
Your modified BIOS image is at the bottom of this post.
The modified BIOS image's name within the archive is "bios_mod.ROM". You may need to rename it to "bios.wph" before flashing it.
The Main Menu was upgraded with a customized version. The Advanced Menu's 'ICH Sata Pata Control Sub-Menu' was replaced by the Turbo Memory setting. The 'ICH Sata Pata Control Sub-Menu' now appears in the Intel Menu. The Intel and "MCH Workarounds:" Menus were added to the BIOS.
Generic Warnings/Disclaimers:
Quote:Please remember to take proper precautions when flashing your BIOS. Even if the image is safe, the flashing process can still fail. Make sure that (if applicable) your notebook is fully charged (100%), the power plug is properly connected, and that the chance of the power going out is as minimal as possible. Do not interrupt the flashing process. If possible, it is a good idea to have a working CRISIS recovery disk when messing with your BIOS. Use the flashing instructions for your particular computer brand. DO NOT DO ANYTHING UNNECESSARY!!!
I take absolutely NO responsibility for ANY damages that may occur to you, your computer, your personal belongings, your neighbor's cat, or any other personnel or equipment as a direct or indirect result/consequence of your, or any one else's, use or misuse of any of the files that are in this archive at the present or at any time in the past or the future. You assume full responsibility for any damages or inconveniences that may occur by choosing to flash, or otherwise use or misuse, this image or any of the other files within this archive.
Have fun!
Please remember to post the results of the BIOS flash. Pictures of the "Main" and "MCH Workarounds:" Menus are especially helpful (the others are not important)!
08-15-2014, 08:29 PM (This post was last modified: 08-17-2014, 07:13 PM by Sml6397.)
Hello sencija,
Could you upload your dumped CMOS NVRAM Token Table please? I want to check if the settings are actually being saved. Before you do this though, go to your BIOS menus, change the desired settings again, and press "F10" to save them. If this does not work, then proceed with the instructions below.
To dump your NVRAM Token Table, follow the following:
1.) Create a bootable flashdrive or CD with DOS on it.
2.) After that, extract this archive onto the flashdrive. The file inside is the symcmos program.
3.) Boot into your bootable DOS media and run the following command:
Quote:symcmos -v2 -LDefault.txt ; "Default.txt" is an example file name
4.) Upload the file that you created by running the command above. This .txt file is a copy of all of the saved BIOS settings from the CMOS NVRAM. I am going to check if the settings were saved when you changed them.
!!!!!PLEASE READ!!!!!! Our Ukrainian friends are undergoing atrocities right now and need support. There are two things you can do for starters:
1.) Donate to one of various organizations offering medical, military, and psychological support to those impacted: Support Organizations
2.) Combat misinformation on social media.
Also, please feel free to PM me if I have not replied again about your BIOS mod request after 5 days.
Posts: 10
Threads: 2
Joined: Aug 2014
Reputation:
0
08-16-2014, 04:54 AM (This post was last modified: 08-16-2014, 05:44 AM by sencija.)
Hello, I'll post the other part you asked me today. Namely it saves it (as I turn it off the setting are unchanged) but again it only spins when the CPU is over 57C.
I really hoped this would fix it, since else I have to mode it to make it run always 100%.
Here is the included txt.
Posts: 1,219
Threads: 62
Joined: Mar 2013
Reputation:
45
![[-]](https://www.bios-mods.com/forum/images/black/collapse.png "[-]")
.
![[Valid RSS]](valid-rss.png "Validate my RSS feed")