[REQUEST] Lenovo G510 (79CNxxWW) Whitelist Removal

[anghelush20]

Here You go :

http://rghost.net/60560968

Let me know
Regards

P.S. if appreciate my work and time Donate to me . . . look into my Signature

Thank you very much for your fast reply.
Sadly, i got the famous Error 280 message...

next step... in order to change my wificard i'll have to change the laptop

[anghelush20]

ok Lenovo, now i'm P...ed
i'mma do it the old fashioned way... guess you like it the hard(ware) way. the programmer way it is

[Gruberek]

ok Lenovo, now i'm P...ed
i'mma do it the old fashioned way... guess you like it the hard(ware) way. the programmer way it is

Hi
You need CH341A programmer and SOP8 Test Clip. The entire set costs ~10 USD in China.

Regards

[anghelush20]

Thanks Gruberek. Order already placed. Just that it usually takes a month till i receive the parcels from china.

But as a promise, after i get them, if anyone has same problem please contact me and i will gladly help

[mfniazi]

Hello to All

Previously I have requested you guys to remove the WiFi whitelist from my Lenovo G510 laptop and you guys have given me the updated Bios file. Unfortunately, I was stuck due to Error 280 (Write-protection).

I have now bought the CH341A programmer and SOIC8 SOP8 clip. The links of the both stuff are mentioned below:

http://www.ebay.com/itm/271658928370

http://www.ebay.com/itm/281507545064

The seller has also provided a software to use the programmer. I will now request you all to kindly guide me how can I program my Bios now. 

Best regards

[Gruberek]

Hi.
Read your Eeprom Chip and upload here full dump firmware.

Regards

[mfniazi]

Hi.
Read your Eeprom Chip and upload here full dump firmware.

Regards

Hi


Can you please guide me how to use the Software that has come along with the programmer? I attaching the software file with this message.

I am waiting for a kind response.

[Gruberek]

ok friend,
get this software - http://www16.zippyshare.com/v/kdW9z5Bw/file.html
and drivers - http://www16.zippyshare.com/v/AIFsO9r4/file.html

Install the drivers, connect the programmer and run the program.



Check that the device has been detected (for me it is red, because I have no programmer attached). If it is connected, connect the programmer to EEPROM chip.



After connecting, click "Detect" to detect EEPROM chip.



Finally, click on read eeprom, save the file and upload here.

[mfniazi]

ok friend,
get this software - http://www16.zippyshare.com/v/kdW9z5Bw/file.html
and drivers - http://www16.zippyshare.com/v/AIFsO9r4/file.html

Install the drivers, connect the programmer and run the program.



Check that the device has been detected (for me it is red, because I have no programmer attached). If it is connected, connect the programmer to EEPROM chip.



After connecting, click "Detect" to detect EEPROM chip.



Finally, click on read eeprom, save the file and upload here.

Hi

Should I disconnect the CMOS battery during this process? 

I will soon upload the file. Thanks very much.

[Gruberek]

No need to disconnect the CMOS battery.