i tried flash it into cmd and sleep bug but give me :
Error 7: Hardware sequencing failed. Make sure that you have access to target fl
ash area!
try .... if you have any difficulties, will address
(05-27-2015, 08:40 AM)BDMaster Wrote: [ -> ]I am sorry but there aren't so only using an SPI Programmer is possible this job !
Look here :
https://www.bios-mods.com/forum/Thread-R...5#pid74575
regrads
So, if I buy the SPI Programmer and follow the guide, I'll be able to use another wifi card, etc... ?
Just need to buy that and the modded bios!
I will help to make this job !
Regards
Hi all,
I'm going to buy CH431A programmer (
http://allegro.pl/programator-ch341a-24x...05896.html), but not in the list of supported my bios chip number. Please let us know whether this programmer will work with the BIOS chip.
Chip bios:
25R064A
13ECO
99 CHN
350018
Regards
Witamy przyjaciela !!!
Your choice is Super !
Regards
(09-02-2015, 08:48 AM)BDMaster Wrote: [ -> ]Witamy przyjaciela !!!
Your choice is Super !
Regards
Witam,
Hello,
I made an attempt to upload the modified BIOS by using the programmer CH341A, but the attempt failed:
1.
The programmer mistakenly recognized my chip detects it as a chip “128bit” instead of 8MB.
2.
I changed in the program to the chip COMMON 25X64.
3.
I made a backup of BIOS loaded.
4.
I programmed the chip with modified bios.
5.
Computer after step 4 did not start.
6.
I programmed the BIOS with my backup (created in step 3. - from the programmer).
7.
The computer is normally launched.
I am attaching my backup BIOS (programmer).
http://rghost.net/85QMgZ4V4
Please warmly about some advice.
Regards
Rafał