Login

dom93 · 03-06-2020, 01:33 PM

So why keeps displaying "unsupported cpu" on boot? If I press f1 it boots fine, if I don't it shuts down

***DeathBringer*** · 03-06-2020, 01:40 PM

It isn't microcode issue.

dom93 · 03-06-2020, 01:42 PM

in the manual of hp pro 3300 there are only a few supported cpus, so I think the microcode has been modified to support only cpu listed in the manual

***DeathBringer*** · 03-06-2020, 01:57 PM

Make BIOS dump by your hardware programmer.

dom93 · (This post was last modified: 03-06-2020, 02:11 PM by dom93.)

(03-06-2020, 01:57 PM)DeathBringer Wrote: Make BIOS dump by your hardware programmer.

Here it is

.bin

backup_716.bin (Size: 4 MB / Downloads: 76)

***DeathBringer*** · 03-06-2020, 02:47 PM

Try to flash my mod.

dom93 · 03-06-2020, 03:25 PM

(03-06-2020, 02:47 PM)DeathBringer Wrote: Try to flash my mod.

Thanks a lot, it worked!

***DeathBringer*** · (This post was last modified: 03-06-2020, 03:28 PM by DeathBringer.)

Nice news! It was TDP issue.
I patched only two bytes:
0x3B6029: DE -> 69
0x3B9025: 76 -> EB

art913 · 03-08-2020, 07:08 PM

(03-06-2020, 02:47 PM)DeathBringer Wrote: Try to flash my mod.

Please upload the file again. The link does not open

***DeathBringer*** · 03-09-2020, 04:01 AM

(03-08-2020, 07:08 PM)art913 Wrote: The link does not open

It was mod for dom93's mod only. You can make mod yourself. Change two bytes - https://www.bios-mods.com/forum/Thread-H...#pid163137