[REQUEST] Asus ROG GL502VSK (Kaby Lake) BIOS Unlock

[Lost_N_BIOS]

If you have the programmer attached backwards it can heat up the chip super hot in a very short time (Seconds), it will burn your finger almost, so feel for that or make sure it's all correct. Here is an image guide on how to hook it all up
https://www.bios-mods.com/forum/Thread-G...programmer

Other than that, as long as you do not write to the chip, it should be fine. You may not get verified or valid dump until you find the right software version or chip ID. If W25Q64FV choose BV instead and use software 1.30

[fullmetaljacket7]

Great! I'm good to go then.
Thanks!

[MZWiZard]

Can this be applied to a GL702VSK as well?

[eshield]

Can this be applied to a GL702VSK as well?

Well, it's better to ask Lost_N_BIOS. He is the wizard here 

[Lost_N_BIOS]

Sorry MZWizard, I remember trying to unlock your BIOS already and I don't think we made any progress

So no, not same method for your system, I think Feluchi or someone else will have to unlock that for you, then if you give me the BIOS I can see method used, but other than that I've sent you 25+ edited BIOS and no luck

[BuP4uk]

gl502vsk 7700hq anyone can moding?

[Fanstamo]

Hello. gl502vsk 7700hq anyone can moding please?

[BuP4uk]

Hello. gl502vsk 7700hq anyone can moding please?

Yeah! me want too!

[Fanstamo]

Получилось анлокнуть биос на 7700?

[BuP4uk]

https://dropmefiles.com/OEFUw

ROG GL502VSK : Version 309
Please confirm bios version is identical with I modified before you do anything.
Notice : BIOS Lock, Variable: 0x8A8

Following the step in below to generate a modified bios on your machine and flashing it.

1.>(dump bios)
Run dump.bat as administrator ,it will generate a dump.rom file at the same directory ,this bios file is exclusive for your machine.

2.>(replace module)
Run replace.bat as administrator ,it will replace some modified modules base on your
dump bios and make a unlocked bios that names dump2.rom.(It may take few seconds and some command windows appears.)

3.>(change variable)
Copy folder "EFI" to a usb pen drive that already format to fat32 then reboot system ,then boot this usb device as uefi model ,it will enter to GRUB sell environment.
You should now see a screen similar with grub_shell.jpg.

Type setup_var 0x8A8 0x0 then press enter ,if no any error happen ,you will get some message about offset 0x8A8 to 0x00.

Exit GRUB shell and return to operation system.

4.>(re-flash bios)
Run flash.bat as administrator to flash modded.

Done