GA-EP45T-UD3LR

[PitKoz]

Hi back, I am after big storms in real life setting up hardware and struggling with money for opening my ART production.
My no "cable on floor policy" is pending, my terra station works well my ups is protecting all from Irish electrical supply standards...LOL

[Lost_N_BIOS]

Irish electrical supply standards

Do you guys have unstable delivery, lots of fluctuations, or just joking?

[PitKoz]

Here is what happens with bios starupnow.
and after it shows voltage and tunning error than with no changes I save bios it restarts computer again and than it works as Lamborgini... I am really lost

[PitKoz]

Irish electrical supply standards

Do you guys have unstable delivery, lots of fluctuations, or just joking?

unscheduled switch offs, sparking supplies, then switch offs, dropping voltage... and plenty more.

[PitKoz]

Hi, Lost, I have plenty to talk about this case... but so little time... we must set up kind of voice chat session, maybe on Discord or similar

[PitKoz]

I had saved several bios setups but had no time to decode them... even did not research how to do it...

[PitKoz]

now I started PC without saving tuning from Gigab in BIOS and checked Speccy all works as expected and should voltages clocks and more...

[Lost_N_BIOS]

Many fast beeps like that is memory error, either memory in wrong slots, incompatible or faulty memory, or bad memory settings. When it finally starts, that is BIOS loading fail safe defaults, you don't want that. Load optimized, set your memory up manually and try again.

[PitKoz]

I did many times, all the way it goes the same way... None reset helps, but it is only when I start it after quite a time of switched off time, when warm it restarts smoothly.
There was some strange feeling that it may be cold soldering and some issues with the capacitor for upkeep for 0.5s of in very sophisticated 850 W server PSU... but really can not research it.
This has started after, maybe you remember, fail to switch to 3.2 GHz 1600 Xenon.. and when I put back this 3.0 1333 it never went back to the stable start of PC. Before 3.0 1333 was starting with no problems.

PS.: How to decode saved bios set-ups to see and compare the parameters it starts with?

[PitKoz]

Many fast beeps like that is memory error, either memory in wrong slots, incompatible or faulty memory, or bad memory settings.  When it finally starts, that is BIOS loading fail safe defaults, you don't want that.  Load optimized, set your memory up manually and try again.

Fail-safe, from this you say, results in same, in windows, parameters discovered in Speccy. No changes, It looks like Bios is disregarding hardware and setup and starts something or tests something on hardware, then gives "fail safe" which are, when the kernel starts, changed to the optimized for hardware by the kernel.